Motley Mods llc
Cart 0

Varitube v2 Installation

Only 11.5mm long - note you need an additional 2.5mm-3mm to allow movement within the installation
 
Note -  Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector ... This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation.  Pre-loading the spring with an over tightened T-Nut may result in 'ratchety' movement while installing an atomizer ... Adjust the T-Nut prior to soldering!
Ultra low profile shoulder, self-adjusting spring loaded center pin, brass backer nut for solid and secure installation.  
Made of Stainless, Brass, & High Temp insulating material this connector is perfect for box mods and the discerning modder!  
  • The spring carries no electrical load!
  • 22mm with Air Channels
  • 22mm Smooth Top
  • Only 1mm thick landing pad
  • Made of Stainless with High Temp Insulator, and brass - rated for 450F degrees continuous service
  • Assembled connector length - 11.5mm - extends to about 14mm with atomizer installed
  • Body threading - M10x0.5 - 10mm diameter ... about 3/8"
  • Ring Terminal for ground connection included
  • Does NOT need to be disassembled for soldering!!!  Huge productivity gain!  Can be soldered after install as well if desired.  Only adjustment needed is to make sure the bottom T-Nut is not over tightened prior to soldering.
  • Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector ... This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation.  Pre-loading the spring with an over tightened T-Nut may result in 'ratchety' movement while installing an atomizer ... Adjust the T-Nut prior to soldering!